beautypg.com

Change the fuse in the vehicle power cable, Mount on your dashboard, Change the fuse in the – Garmin G60 User Manual

Page 91: Vehicle power cable

background image

nüvifone G60 user’s guide

Appendix

Change the Fuse in the

Vehicle Power Cable

If your device does not charge

in your vehicle, you may need to

replace the fuse located at the tip of

the vehicle power cable. The vehicle

power cable is an optional accessory.
nOTE: When replacing the fuse, do

not lose any of the small pieces and

make sure they are put back in the

proper position.

1. Unscrew the

end piece,

and remove it.

2. Remove the

fuse (glass

and silver

cylinder), and

replace it with a 1A fast blow fuse

of the same size.

3. Ensure that the silver tip is

located in the end piece. Screw

on the end piece.

Mount on Your

Dashboard

Use the enclosed mounting disk to

mount your device to the dashboard

and comply with certain state and

local regulations.
nOTE: The permanent mounting

adhesive is extremely difficult to

remove after it is installed.

1. Clean and dry the dashboard

where you are placing the disk.

2. Remove the backing from the

adhesive on the bottom of the

disk.

3. Place the disk on the dashboard.
4. Remove the clear plastic cover

from the top of the disk.

5. Place the suction cup mount

on top of the disk. Flip the lever

down (toward the disk).

End piece

Silver tip

Fuse

End piece

Silver tip

Fuse

This manual is related to the following products: