Chip tray, Feed stop – Grizzly G9744Z User Manual
Page 20
-18-
G9744Z Metal Cutting Bandsaw
Chip Tray
Components and Hardware Needed:
Qty
Chip Tray ........................................................... 1
The chip tray fits over the lip of the base as illus-
trated in
Figure 10.
Figure 10. Chip tray installed.
Figure 11. Feed stop.
Jam Nut
Feed Stop
Feed Stop
Depending on how the Model G9744Z was
shipped, it may be necessary to adjust the feed
stop before the test run. The blade should not
make contact with any part of the vise assembly.
To adjust the feed stop bolt:
1. Adjust the feed stop bolt and jam nut (Figure
11), so the bandsaw blade teeth are just
below the vise table surface when the cut is
complete.
See also other documents in the category Grizzly Power saws:
- G0506 (56 pages)
- 12" Cold Cut Saw G0682 (52 pages)
- G1127 (3 pages)
- 24" & 27" Resaw Bandsaws G3619 (56 pages)
- H7197 (1 page)
- INDUSTRIAL BANDSAW W/FOOT BRAKE G0513X2F (108 pages)
- Heavy-Duty Table G1023Z (63 pages)
- G0641 (56 pages)
- Air Cut-Off G8122 (2 pages)
- Ultimate 14" Bandsaw G0555 (68 pages)
- G4186Z (48 pages)
- H8145 (36 pages)
- G0691 (11 pages)
- G0691 (92 pages)
- G0592 (60 pages)
- Model G1022proz (84 pages)
- G0605X1-6X1 (12 pages)
- Model G1023zx3 (63 pages)
- G1016 (30 pages)
- H0604 (10 pages)
- ZX (63 pages)
- g0531b (8 pages)
- G3620 (56 pages)
- G1023SL (50 pages)
- G1023SLWX (3 pages)
- 50/65 Ton Ironworker G0647 (76 pages)
- Zero Clearance Table Insert H7396 (1 page)
- H7583 (28 pages)
- G0621 (60 pages)
- G0457 (64 pages)
- G0605X1 (101 pages)
- H0629 (3 pages)
- Slow Speed Cold Cut G0665 (40 pages)
- G0717 (60 pages)
- G0659 (60 pages)
- G0606X1 (12 pages)
- G0605X/G0606X (76 pages)
- G5787 (37 pages)
- G8599 (13 pages)
- T10131 (4 pages)
- G0513P (108 pages)
- G9906 (14 pages)
- G0513X2 (108 pages)
- G7211 (34 pages)
- G1052 (34 pages)