GE Autotrol Performa ProSoft 960 Series - Manual (Page 9)

9
Table 3 - Level II Programming Parameters
Parameter
Name Description Range of Values
Minimum
Increments
Default
Units of
Measure
Notes
P6 Refill controller 1 to 99 1 33
Enter the value molded into the
end of the refill controller.
P7
Regenerant
draw value
1 to 99 1 25
Select number from Table 4 and
enter that number.
P8 Not used NA NA NA NA NA
P9 Backwash time 3 to 30 1 14 Minutes
Skip this parameter to accept the
default or enter a value.
P10 Slow rinse time 8 to 125 1 40 Minutes
Skip this parameter to accept the
default or enter a value.
P11 Fast rinse time 2 to 19 1 4 Minutes
Skip this parameter to accept the
default or enter a value.
P12 Units of Measure 0 to 1 1 0
0 = U.S., 1 = metric. Skip this
parameter to accept U.S. or enter
1 for metric.
P13 Clock mode 0 to 1 1 0
0 = 12-hour clock.
1 = 24-hour clock. Skip this
parameter for a 12-hour clock or
enter 1 for a 24-hour clock.
P14
Calendar
override
0 to 30 1 0 Days
0 = no calendar override. Skip this
parameter for no calendar
override or enter a value.
P15 Reserve type 0 to 3 1 0
0 = variable reserve, 1 = fixed
reserve, 2 = variable reserve with
immediate regen,
3 = fixed reserve with immediate
regen. Skip this parameter to
accept the default or enter a
different reserve type.
P16
Fixed reserve
capacity or initial
average value
0 to 70 1 30
Percent of
capacity
Description depends on the value
entered for P15. Skip this
parameter to accept the default or
enter a different value.
P17 Operation type 0 to 2 1 2
2 = 5-cycle
cocurrent conditioner.
P18
Salt/capacity
change lockout
0 to 1 1 0
0 = none, 1 = salt/capacity change
locked out. Skip this parameter to
accept the default or enter 1 to
lock out salt/capacity change.
P19 Factory defaults 1 99
Loads in a set of default values.
Refer to the Special Notes for
Level II Parameters section in this
manual. Do Not Change.