Grizzly 12" Cold Cut Saw G0682 - Manual (Page 16)

-14-
g0682 12" Cold Cut saw (mfg. since 12/10)
Workbench Mounting
the model g0682 can be used without the includ-
ed stand. if you choose to mount the machine to
a workbench, use one of the methods described
below.
the strongest mounting option is a "through
mount" where holes are drilled all the way through
the workbench, and hex bolts, washers, and hex
nuts are used to secure the drill press to the work-
bench.
NOTICE
Anchor studs are stronger and more per-
manent alternatives to lag shield anchors;
however, they will stick out of the floor,
which may cause a tripping hazard if you
decide to move your machine.
figure 8. typical fasteners for mounting to
concrete floors.
anchor stud
lag shield anchor
lag bolt
Mounting
Machine Base
Workbench
Bolt
Flat Washer
Flat Washer
Lock Washer
Hex Nut
figure 6. example of a through mount setup.
Machine Base
Workbench
Lag Screw
Flat Washer
figure 7. example of a direct mount setup.
another option for mounting is a "direct mount"
where the machine is simply secured to the work-
bench with a lag screw.
bolting to Concrete floors
although not required, we recommend that you
mount your new machine to the floor. this will
require drilling holes in the stand. because this
is an optional step and floor materials may vary,
floor mounting hardware is not included.
lag shield anchors with lag bolts (see figure 8)
and anchor studs are two popular methods for
anchoring an object to a concrete floor. We sug-
gest you research the many options and methods
for mounting your machine and choose the best
that fits your specific application.