GE D-GES7600 User Manual

Page 56

User’s Manual

Manageable 8/9-Port Switch

Step 3: Get Community Name
Move to highlight Get Community Name, and press .
Enter text and press .

Step 4: Set Community Name
Move to highlight Set Community Name, and press . Enter text and press .

Step 5: Trap Community Name
Move to highlight Trap Community Name 1 and press . Enter text and press .
Repeat to specify up to three more trap community names.

Step 6: Trap Host IP Address
Move to highlight Trap Host 1 IP Address, and press . Type an IP address for trap host 1
and press . Repeat to specify up to two more trap host IP addresses.

Step 7: Cold Start Trap
Move to highlight Cold Start Trap, and press . Decide to have it Disabled or Enabled.

Step 8: Warm Start Trap
Move to highlight Warm Start Trap, and press . Decide to have it Disabled or Enabled.

Step 9: Link Down Trap
Move to highlight Link Down Trap, and press . Decide to have it Disabled or Enabled.

Step 10: Link Up Trap
Move to highlight Link Up Trap, and press . Decide to have it Disabled or Enabled.

Step 11: Authentication Failure Trap
Move to highlight Authentication Failure Trap, and press .
Decide to have it Disabled or Enabled.

Step 12: Rising Alarm Trap
Move to highlight Rising Alarm Trap, and press .
Decide to have it Disabled or Enabled.

Step 13: Falling Alarm Trap
Move to highlight Falling Alarm Trap, and press .
Decide to have it Disabled or Enabled.

Step 14: Topology Change Trap
Move to highlight Topology Change Trap, and press .
Decide to have it Disabled or Enabled.