Supplies/tools – Grizzly H7582 User Manual
Page 7
Model H7582 Junior Electric Guitar Kit
-5-
The majority of the wooden components in this kit
are fully machined from the factory and are ready
for assembly. A small amount of sanding and
finishing will need to be performed to complete
your guitar.
Recommended Tools & Supplies:
•
18" Metal Straightedge with a
1
⁄
32
"
Resolution
•
ANSI Approved Respirator
•
ANSI Approved Safety Glasses
•
Aluminum-Oxide Sanding Paper #220 and
#320 Grit
•
Wet and Dry Sanding Paper #400, #600, and
#1000 Grit (Optional)
•
Tweezers or Pliers
•
8, 10, 11, and 13mm Wrenches
•
Flexible Sanding Block
•
Phillips Screwdriver #1, #2
•
Temporary Wood Neck: Approximately 1" x
2" x 16"
Supplies/Tools
•
Wood Screws #7 x 1
1
⁄
2
" (4)
•
Drill
•
Drill Bit:
5
⁄
16
"
•
1
⁄
4
" Steel Rod, or a Coat Hanger
•
Masking Tape
•
Tack Cloth or Clean Soft Rag
•
Spray Primer and Finish (*See Note)
•
Buffing Compounds (Optional)
•
Soldering Iron and Solder
•
Peghead Reamer or a Round File
•
Hammer
•
Wooden Block: Approximately 4" x 8"
•
Guitar Capo
•
Feeler Gauge Set
•
Wire Cutters
•
Rubber Cement
•
9V Battery
Note: Use the same type of paint for primer
and finish—either enamel or lacquer base.
Do not use different base paints for priming
or finishing or your results may not be desir-
able.