GE 45129 - Manual (Page 9)

8
1 2 3 4
Arm
Zone
Armed Power 1 2 3 4
Alert
Chime
Off
Mute
Learn
Input DC 12V
- +
Zone 4
Continuosly Monitors
any area, in and around
the home, using any
combination of the
four Sensors
Note: Zone 4 is not
affected by Notification
mode switch, and does
not activate alarm
Deticated Alert
Zone (Zone 4)
1 2 3 4
Arm
Zone
Armed Power 1 2 3 4
Alert
Chime
Off
Mute
Learn
Input DC 12V
- +
Mode settings
Control Center has
three Mode settings
“Alert” - Continuous Tone
“Chime” - Single Tone
“Off” - Lights only
Notification switch
(affects Zone 1, 2, 3 only)
Step 1 -
A. Press and hold the Learn button (unit will beep).
B. While continuing to press the Learn button,
press and hold Arm button (within three seconds).
C. When Control Center sounds a long beep, release
buttons. The green LED power indicator will begin
flashingThis indicates the unit is ready to change the
Security Code.
Step 2 -
While the LED indicator is flashing, enter the
current Security Code (if new, then enter the factory
Security Code of ‘1 2 3 4’.)
Step 3 -
Enter your new four digit Code.
Step 4 -
A. Enter your new four digit Code again
to confirm.
B. A long ‘beep’ will sound and the green LED
indicator will stop flashing. Your new Code has
been set.
Note:
- If the Security Code is lost or forgotten, you can restore the
Control Center back to factory default Security Code setting
(‘1 2 3 4’). Remove the batteries and AC adapter. Press
and hold the Learn button and plug the AC adapter
back in (continue pressing the Learn button). Wait until
all 4 Zone LED indicators are on and the Zone 1 LED indicator
begins to flash. The Control Center will need four hours to
reset the Security Code back to the factory Default ‘1 2 3 4’.
Once all Zone LED indicators turn off, the system will be
reset to the factory default. The alarm system
cannot be used during this four hour reset process.
Sensors and Zones
There are four Zones, and each Zone can hold up to
four Sensors - Any combination of Sensors (Motion,
Door, Water or Garage) can be assigned to any of the
four Zones. If you decide to expand, it is important
to know you can always add more Sensors, (16 total).
Zones , and are designated for Arm/Alarm,
or Notification modes.
Zone 4 is designated for detected Alerts only. Use
Zone 4 for areas you wish to continuously monitor,
but don’t want to trigger the alarm (e.g. notification
of water leaks, garage door is up, back gate left