Grizzly G0518 - Manual (Page 25)

G0518 Drum / Flap Sander -23-
Figure 23. Flap sanding.
3. Wear safety glasses, a dust mask and
hearing protection at all times when oper-
ating the sander.
4. Plug the machine into the power source,
press the ON switch and wait for the sander
to reach full speed
.
5. Once the sander has reached full speed, you
can begin sanding the workpiece (
Figure
23 ). Note– Move the workpiece back and
forth across the entire sanding surface to
ensure maximum sanding surface life and to
achieve the best finish results.
Flap Sanding
To correctly perform a flap sanding operation:
1. Unplug the machine from the power
source!
2. If not already installed, mount the flap sander
as described on
Page 18-19 . When attached
correctly, the flap sander should resemble
Figure 22 .
Figure 22. Correctly installed flap sander.