Grizzly G0518 - Manual (Page 16)

-14- G0518 Drum / Flap Sander
Beginning Assembly Stand To Base
Figure 5. Stand attached to base.
Loose hair and clothing
could get caught in
machinery and cause
serious personal injury.
Keep loose clothing
rolled up and long hair
tied up and away from
machinery.
Serious personal injury
could occur if you con-
nect your machine to the
power source before you
have completed the
assembly process. DO
NOT connect the
machine to the power
source until instructed to
do so. !
Sharp edges on metal
parts may cause person-
al injury. Examine the
edges of all metal parts
before handling.
To attach the stand to the base:
Attach the stand to the base with (4) M8-1.25 x 20
cap screws, (4) M8 flat washers, (4) M8 lock
washers and (4) M8-1.25 hex flange nuts (
Figure
5 ). Note– The lock washers should be installed
between the flat washers and the head of the cap
screws.
This section will cover the basic assembly and
adjustment instructions needed to begin opera-
tion. Complete the assembly in the order provid-
ed in this manual and then read the remaining
portion of the manual before attempting any type
of operation.
Your safety is important! Please follow the
warnings below during this entire section:
Fasteners
Stand
Base