Great Dane GSRKA1934S - Manual (Page 6)

SAFETY
SAFETY - 4
CAUTION (H)
Be safe! To avoid a fire hazard remove all leaves, grass
and debris from engine, hydro pumps and motors, pulleys,
belts, hoses, engine deck and cutter deck.
DANGER/POISON (I)
• Shield Eyes: Explosive gases can cause blindness or
injury.
• NO
• Sparks
• Flames
• Smoking
• Sulfuric acid can cause blindness or severe burns.
• Flush eyes immediately with water. Get medical help fast.
• Keep out of reach of children.
• Do not tip.
• Do not open battery.
WARNING (J)
To avoid injury from tipover, drive across slopes, not up and
down. If machine stops going uphill, stop blades and back
down slowly.
Emission Control System Certification Label
NOTE: Tampering with emission controls and components
by unauthorized personnel may result in severe fines or
penalties. Emission controls and components can only be
adjusted by EPA and/or CARB authorized service centers.
Contact your Great Dane Equipment Retailer concerning
emission controls and component questions.
The presence of an emissions label signifies that the en-
gine has been certified with the United States Environmen-
tal Protection Agency (EPA) and/or California Air Resources
Board (CARB).
The emissions warranty applies only to those engines mar-
keted by Great Dane that have been certified by the EPA
and/or CARB; and used in the United States and Canada in
off-road mobile equipment.
Emission Compliance Period
If your engine has the emission compliance category listed
on the emission control system certification or air index
label, this indicates the number of operating hours for which
the engine has been certified to meet EPA and/or CARB
emission requirements. The following table provides the
engine compliance period in hours associated with the
category found on the certification label.
Agency Category Hours
EPA C 250
EPA B 500
EPA A 1000
CARB Moderate 125
CARB Intermediate 250
CARB Extended 500
Certification
Your product has been tested and evaluated by the manu-
facturer and conforms with American National Standard
B-71.4, “Safety Specifications” for commercial turf care
equipment.
Safety
Operator Training Required
Read the operator’s manual and other training mate-
rial. If the operator or mechanic cannot read English, it
is the owner’s responsibility to explain this material to
them. This publication is available in other languages.
Become familiar with the safe operation of the equip-
ment, operator controls, and safety signs.
All operators and mechanics should be trained. The
owner of the machine is responsible for training the
users.
Never let children or untrained people operate or ser-
vice the equipment. Local regulations may restrict the
age of the operator.
The owner/user can prevent and is responsible for
accidents or injuries occurring to themselves, other
people, or property.
Operate the machine in an open, unobstructed area
under the direction of an experienced operator.
Preparation
Evaluate the terrain to determine what accessories and
attachments are needed to properly and safely perform
•
•
•
•
•
•
•