Graco DELTA SPRAY XT GUN 310692D - Manual (Page 9)

Setup
310692D 9
Setup
Flushing the gun
1. To flush the gun, use a solvent that is compatible
with paint to be sprayed. Hold a metal part of the
gun firmly to a grounded metal pail. Trigger the gun
to flush solvent through gun.
Connecting the air line
2. Install an air pressure regulator (F). See F IG . 1.
3. Install an air filter (G). See F IG . 1.
4. Use a 5/16 inch (7.9 mm) I.D. air hose to minimize
excessive pressure drop in the hose.
5. Connect the air hose (D) to the 1/4 npsm gun air
inlet (C).
6. Connect the other end of the air hose (D) to a regu-
lated air supply line.
Flush the spray gun before putting any paint
through the gun.
WARNING
Read warnings, page 3. Follow Top and bottom feed
guns installation, page 8.
F IG . 2
ti4836a
F IG . 3
F IG . 4
ti4837a
C
D
ti4838a
D