Graco DELTA SPRAY XT GUN 310692D - Manual (Page 6)

Gun Selection
6 310692D
Gun Selection
HVLP Guns
An HVLP gun is a high transfer efficiency gun which lim-
its the air pressure at the aircap to 10 psi maximum. In
some areas, an HVLP gun is required for compliance
with environmental standards.
Compliant Guns
A compliant gun is a high transfer efficiency gun which
has been tested to have a transfer efficiency greater
than or equal to HVLP guns. The Graco compliant guns
have no restrictions on aircap pressures, but the gun
inlet pressure must remain under 29 psi (21 MPa 2.1
bar) to remain in compliance.
Airspray Guns
Excellent atomization and high production rates typically
with some reduction in transfer efficiency.
Air Caps
The chart below lists the air caps available for pressure
feed, gravity, and siphon feed guns.
* Measured with gun nozzle 8 in. (203 mm) from target
surface.
Spray Gun
Air Cap
ID
Typical Pattern
Width*
in. (mm) Gun Feed
Nozzle Orifice
in. (mm)
Part
Number
HVLP 321 15 (381) Pressure Feed .030-.070
(.75-1.8)
234753
HVLP 322 15 (381) Pressure Feed .086 (2.2) 234754
HVLP 323 15 (381) Pressure Feed .110 (2.8) 234755
HVLP 320 12 (305) Gravity/Siphon
Feed
.030-.070
(.75-1.8)
234752
Compliant 006 11 (279) All Models .030-.070
(.75-1.8)
234762
Airspray 315 13 (330) Pressure Feed .030-.070
(.75-1.8)
234757
Airspray 318 10 (254) Pressure Feed .086 (2.2) 234760
Airspray 319 10 (254) Pressure Feed .110 (2.8) 234761
Airspray 317 9 (229) Gravity/Siphon
Feed
.030-.070
(.75-1.8)
234759
Airspray 313 10 (254) Pressure Feed .030-.070
(.75-1.8)
234756
Airspray 316 10 (254) Pressure Feed .030-.070
(.75-1.8)
234758