Software overview, Introduction, Description – GE P485 User Manual
Page 23: System requirements, Installation procedure, Installing from enervista cd, Installing from the ge multilin website, Introduction –1, Description –1 system requirements –1, Installation procedure –1
P485 MODBUS TO PROFIBUS CONVERTER – USER GUIDE
4–1
GE Consumer & Industrial
P485 Modbus to Profibus
Converter
Chapter 4: Software overview
Software overview
Introduction
DESCRIPTION
EnerVista P485/D485 Setup is a PC-based configuration software used to describe the
protocol and communication properties for a serial network. When the configuration is
finished and the functionality is tested, it is possible to send memory allocation information
to a printer using EnerVista P485/D485 Setup.
EnerVista P485/D485 Setup can also be used for troubleshooting and diagnostic of the
P485 and the serial network during runtime.
SYSTEM REQUIREMENTS
The following hardware and software is required to use the EnerVista P485/D485 Setup
software.
•
Pentium 133 MHz or higher
•
10 MB of free space on the hard drive
•
8 MB RAM
•
Windows 95/98/NT/2000/XP
•
Internet Explorer 4.01 SP1 or higher
Installation procedure
DESCRIPTION
There are two different ways of installing EnerVista P485/D485 Setup; either via the GE
EnerVista CD or from the GE Multilin website at
.
INSTALLING FROM
ENERVISTA CD
Run ‘setup.exe’ and follow the on screen instructions
INSTALLING FROM THE
GE MULTILIN WEBSITE
Download the self-extracting EXE file from the GE Multilin website at
.