Grizzly G9742 - Manual (Page 17)

G9742 Metal Cutting Bandsaw (Mfg. Since 11/06
-15-
Shipping Strap &
Stop Adjustment
To. ensure. that. your. bandsaw. arrives. without.
damage. to. the. hinge. system,. a. shipping. strap.
was.installed..After.removing.the.shipping.strap,.
you. will. have. to. make. a. series. of. adjustments,.
beginning.with.the.feed.stop.bolt..
To remove the shipping strap and adjust the
feed stop bolt:
1.. Remove. the. shipping. strap. hex. bolt. and.
strap.with.a.12mm.wrench.(see. figure 11).
.
.
Note:.Keep this shipping strap in the event that
you must transport or ship the bandsaw.
2.. Adjust.the.feed.stop.bolt.and.jam.nut.with.a.
14mm.wrench.( figure 12),.so.the.bandsaw.
blade.teeth.are.just.below.the.table.surface.
when.the.cut.is.complete.
figure 11 . Removing.shipping.strap.
figure 12. Feed.stop.bolt.
Squaring Vise to
Blade
To.ensure.that.your.bandsaw.will.make.cuts.that.
match.the.degree.scale,.you.must.make.sure.to.
square.the.vise.to.the.blade..
To square the vise to the blade:
1.. Rotate.the.headstock.until.the.pointer.reads.
"0". on. the. tabletop. scale,. and. tighten. the.
headstock.lock.lever.so.the.headstock.stays.
indexed.at.zero.
2.. Using. a. 6mm. wrench,. loosen. the. two. cap.
screws. that. hold. the. vise. to. the. table. (see.
figure 13).
figure 13..Squaring.vise.to.blade,.headstock,.
and.table.scale.
Headstock.
Lock.Lever
3.. Using. a. small. machinists. square,. adjust. the.
vise.so.it.is.square.to.the.blade.
4.. Tighten.the.two.cap.screws,.so.the.vise.and.
blade.are.square.with.one.another.
Square