Solving print quality problems – Genicom LN45 User Manual
Page 141
Aug 01
Genicom
Publication No. GEG-99126
GENICOM LN45 and Intelliprint mL450 User Guide
6-3
Solving Print Quality Problems
This section describes quality problems during printing. Go through the list below to find the conditon that
most closely resembles the problem and follow the recommended action. If the trouble persists after per-
forming the checks listed below, turn the printer off [ O ], disconnect the power cord from the AC outlet,
and see
”Appendix E GENICOM Customer Support and Part Numbers”
to arrange for a technical support
or service or repair call
DESCRIPTION
POSSIBLE
CAUSE
REQUIRED
ACTION
No power.
Power switch not turned on.
Switch not set to [ I ].
Check power switch. See
”Chapter 1 Unpacking and
Installing Your Printer”
for
Printer” for more information
Power cord not properly
plugged into AC outlet or AC
connector on rear of printer
Set power switch to [ O ]
(off) and plug in power cord
firmly. See
Unpacking and Installing
Your Printer”
for more
information.
Voltage of AC power line not
correct.
Verify that AC outlet is rated
for the correct voltage and
amperage of your printer.
See
for more information.
Power is frequently
interrupted
Printer is defective
Turn printer off [ O ],
disconnect power cord from
the AC outlet. See
E GENICOM Customer
Support and Part Numbers”
to arrange for a technical
support or service or repair
call.
DESCRIPTION
POSSIBLE
CAUSE
REQUIRED
ACTION
Faded print
Print media is moist.
Remove moist media and load new dry
media.
EP cartridge is old or
damaged
Replace EP cartridge. See
Printer Consumables, Cleaning and
Maintenance”
.
Toner in EP cartridge is low.