Grizzly G0594 - Manual (Page 9)

G0594 Large Chipper/Shredder
-7-
No list of safety guidelines can be complete.
Every environment is different. Always con-
sider safety first, as it applies to your indi-
vidual working conditions. Use this and
other machinery with caution and respect.
Failure to do so could result in serious per-
sonal injury, damage to equipment, or poor
work results.
Like all machinery there is potential danger
when operating this machine. Accidents are
frequently caused by lack of familiarity or
failure to pay attention. Use this machine
with respect and caution to lessen the pos-
sibility of operator injury. If normal safety
precautions are overlooked or ignored, seri-
ous personal injury may occur.
7. SECURE FOOTING: Placing the chip-
per/shredder on a slope or slippery surface
may cause the operator to fall into the
machine, causing burns from the motor, or
an amputation if an arm accidentally goes
into the hopper. Wear non-slip, closed toed
shoes or boots to maintain secure footing.
8. JAMS AND CLOGGING: Turn the chip-
per/shredder OFF, allow all moving parts to
come to a complete stop, and disconnect
the spark plug wire before attempting to
free a jam or clog.
9. FEEDING MATERIAL: Hold branches and
brush loosely, and allow the chipper/shred-
der to draw the material in. The machine
sometimes will draw material in very quick-
ly and your hand may be drawn in if you
are holding tightly. If the blades hit a hard
object, or if the machine begins to make
an unusual noise or vibration, immediately
shut the chipper/shredder
OFF.
10. TURN OFF CHIPPER/SHREDDER: Turn
OFF the machine, allow all moving parts
to come to a complete stop, and discon-
nect the spark plug wire before moving the
machine, emptying the bag, unclogging
the inlets or outlets, filling the gas tank, or
performing maintenance and repairs.
11. STARTING THE CHIPPER/SHREDDER:
Make sure the hopper and funnel are
empty when starting the machine. The pull
start cord may stop suddenly causing the
chipper/shredder to fall over or injure your
hand or arm.
12. CLEANING CHIPPER/SHREDDER: Allow
the motor to cool off, then brush dust and
chip build-up off of the motor to prevent fire
or motor overheating.