Inventory, Assembly – Grizzly G0594 User Manual

Page 11

G0594 Large Chipper/Shredder

-9-

Inventory

After all the parts have been removed from the

box, you should have the following items:

Inventory (Figure 3)

Qty

A. Chipper/Shredder ....................................... 1

B. Wheel Assembly ......................................... 2

C. Hopper ........................................................ 1

D. Funnel ......................................................... 1

E. Hopper Gasket ........................................... 1

F. Handles ...................................................... 2

G. Leg ............................................................. 1

H. Toolbox (Contents Not Shown) .................. 1

—Ear Protection ..................................1 Pair

—Safety Goggles ................................1 Pair

—Gloves ..............................................1 Pair

—Oil Funnel ............................................... 1

—Straight Blade Screwdriver ..................... 1

—Wrench 13/15mm .................................... 1

—Wrench 12/14mm .................................... 1

—Spark plug Socket w/Handle

⁄

" ............ 1

Figure 3. Model G0594 inventory.

Hardware (Not Shown)

Qty

•

Hex Bolt M8-1.25 x 35 ............................... 4

•

Rubber Grommets ...................................... 4

•

Phillips Head Screw M8-1.25 x 35 ............. 4

•

Fender Washers 8mm ................................ 4

•

Lock Nuts M8-1.25 ................................... 11

•

Flat Washer 8mm ..................................... 27

•

Lock Washer 8mm ................................... 11

In the event that any nonproprietary parts are

missing (e.g. a nut or a washer), we would be

glad to replace them, or for the sake of expedi-

ency, replacements can be obtained at your local

hardware store.

Assembly

The major components of this chipper/shredder
have been assembled at the factory. Some minor
assembly is required. The assembly process will
use all the parts and hardware listed in the inven-
tory.

DO NOT attempt to start this machine until all
assembly has been completed. Serious personal
injury and damage to the machine could occur.

To assemble the chipper/shredder:

1. Tip the chipper/shredder over and remove

the four bolts shown in

Figure 4. DO NOT

turn the chipper/shredder over once it is full
of oil and gas. The oil and gas will spill out.

2. Attach the wheel assembly and the leg with

the bolts that were removed in

Step 1.

3. Set the chipper shredder upright and set the

hopper gasket around the chute as shown in
Figure 5.

Figure 4. Attaching the leg.

Wheel

Assembly

Bolts

Leg Bolts

Leg