GE MONACO 6000A - Manual (Page 4)

Read entire manual. Failure to follow all guidelines and rules could cause personal injury or property
damage.
• Before you begin installation, read these Installation Instructions completely. Then, obtain all the
materials and tools you will need to make the installation. Failure to properly install the softener
voids the warranty.
• Check local codes. The installation must conform to them.
• Use only lead-free solder and flux for all sweat-solder connections, as required by state and federal
codes.
• Connect the softener to the main water supply pipe before or ahead of the water heater. DO NOT RUN
HOT WATER THROUGH THE SOFTENER.
Temperature of water passing through the softener must be
less than 120° F.
• Use care when handling the softener. Do not turn upside down, drop, drag, or set on sharp
protrusions.
• Maximum allowable inlet water pressure is 125 psi. If daytime pressure is over 80 psi, nighttime
pressure may exceed the maximum. Use a pressure reducing valve if necessary. (Adding a pressure
reducing valve may reduce the flow.)
• The softener works on 24 volt-60 Hz electrical power only. Be sure to use the included transformer.
Be sure the electric outlet and transformer are in an inside location to protect from wet weather.
• See Where to Install the Softener section for more details.
WARNING: Do not use with water that is microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system. The water should be tested periodically to
verify that the system is performing satisfactorily.
Small parts remaining after the installation could be a choke hazard. Discard safely.
4
Installation instructions.
Customer Service
Troubleshooting T
ips
Operating Instructions
Safety Instructions
Operating Instructions
Customer Service
Troubleshooting T
ips
Safety Instructions
Operating Instructions
Customer Service
Troubleshooting T
ips
Safety Instructions
Installation Instructions
CAUTION: Certain plumbing skills are needed for installation. If you are unsure about any part
of the installation of this product, consult a professional plumber.
Unpacking and Inspection
The softener is shipped in one master carton. The softener is completely assembled at the factory,
except as required at installation.
Be sure to check the entire softener for any shipping damage or parts loss. Also note damage to the
shipping cartons. Contact the transportation company for all damage and loss claims. The
manufacturer is not responsible for damages in transit.
Small parts, needed to install the softener, are on a skin-packed cardboard piece. To avoid loss of the
small parts, keep them on the skin-pack until you are ready to use them.
Important Installation Recommendations