Garmin 130 - Manual (Page 42)

36 Rino ® 130 Owner’s Manual
U
NIT
O
PERATION
> N
AVIGATION
P
AGE
To calibrate the Electronic Compass:
1. Use the Page button to access the Navigation
Page.
2. Use the Thumb Stick to highlight the Option
Menu on-screen button and press In.
3. Highlight the Calibrate Compass option and
press the Thumb Stick In.
4. Press the Thumb Stick to activate the Start
button and then follow on-screen directions for
holding and turning the unit. Hold the unit level
when calibrating the compass.
Calibrating the compass: Hold the unit level and
face up. Turn the unit around as shown above.
The unit displays a “Just Right,” “Too Fast,” or
“Too Slow” message for you to adjust your turning
speed as needed.
The “Calibration Successful” message displays
when finished. If a “Calibration Failed” message
displays, repeat the process.
When you manually turn the Compass Off, it stays off
until you manually turn it On again. Sometimes, however,
when you turn the Compass On, the Rino 130 overrides
the Compass and uses the GPS receiver to track your
heading. The criteria for switching between the Compass
and the GPS is customized on the Heading Setup Page
(see section “Heading Setup Page”).
To turn the compass on and off:
• Press and hold the Zoom ( Z) button. A message
appears on the screen indicating that the compass
has been turned on or off.
• Press the Page button to access the Main Menu.
Select Setup and then System. Turn the compass
on and off through the System Setup Page (see
section “System Setup Page”).