Setup tones, Setup scanlist – Garmin 130 User Manual
Page 22
16
Rino
®
130 Owner’s Manual
U
NIT
O
PERATION
>
R
ADIO
P
AGE
Setup Tones
Call Tone—When the Call button is pressed, an attention
tone is transmitted. This option allows you to choose one
of ten tones.
Roger Tone—When the Talk button is released, a tone
is sent to signify the end of the transmission. This option
allows you to choose one of four tones, or set the tone to
Off.
Ring Tone—When an incoming transmission is received,
an attention tone will sound. This option allows you to
choose one of ten tones or set the tone to Off. The Ring
tone will not sound again until there has been 45 seconds
of radio inactivity.
Vibrate—Choose from On or Off to have the unit
vibrate when an incoming transmission is received. Once
received, the unit will not vibrate again until there has
been 45 seconds of radio inactivity.
On/Off Tone—Enable or disable the tone the unit makes
when it is turned on and off.
Message Tone—Choose from On or Off to have the unit
emit a tone when a message or note is received.
Setup Tones Page
Setup Scanlist
Refer to “Scanning and Monitoring” for complete
information about this feature and the options in
this page.
Setup Scanlist Page