Setting up the monitor, To attach the base – Gateway EV730 User Manual
Page 4
2
Chapter 1: Using Your EV730 Monitor
www.gateway.com
Setting up the monitor
Setting up the monitor consists of two procedures: attaching the base and
connecting the monitor cables. If you are setting up your computer for the first
time, see the setup poster for more information about connecting additional
peripheral devices.
To attach the base:
1
Carefully set the monitor on its side with the bottom of the monitor facing
you.
2
Hold the base so the rounded end is pointing toward the back of the
monitor, then align the hooks on the bottom of the base with the
corresponding slots on the bottom of the monitor.
3
Slide the base toward the front of the monitor so all hooks are securely in
place. The retaining latch clicks into place when the base is attached
correctly.
4
Carefully set the monitor upright and place it on a sturdy, level surface.
Retaining latch