Garmin Edge 500 User Manual

Page 30

Edge 500 Owner’s Manual

ANT+ Sensors

Reset

button

Cable

ties

Indication

line

GSC 10 on rear

Chain Stay

2. Loosely attach the GSC 10 using

two cable ties.

3. Attach the pedal magnet to the

crank arm using the adhesive mount

and a cable tie.
The pedal magnet must be

within 5 mm of the GSC 10. The

indication line on the pedal magnet

must line up with the indication line

on the GSC 10.

Cable

tie

Pedal Magnet on

Crank Arm

Indication

line

4. Unscrew the spoke magnet from the

plastic piece.

5. Place the spoke in the groove of the

plastic piece and tighten slightly.
The spoke magnet can face away

from the GSC 10 if there is not

enough room between the sensor

arm and the spoke. The spoke

magnet must line up with the

indication line on the sensor arm.