GE Monogram 164D3333P095 - Manual (Page 35)

35
PROBLEM POSSIBLE CAUSE
OVEN WILL NOT • The oven temperature is too high to set a self-clean operation.
SELF CLEAN Allow the oven to cool to room temperature and reset the controls.
• Oven controls improperly set. See the Using the Self-Cleaning Oven
section.
• The probe is plugged into the outlet in the oven. Remove the probe
from the oven.
“CRACKING” OR • This is normal. It is the sound of the metal heating and cooling
“POPPING” SOUND during both cooking and cleaning functions.
EXCESSIVE SMOKING • Excessive soil. Press the CLEAR/OFF pad. Open the windows to rid
the room of smoke. Wait until the LOCKED DOOR light goes off.
Wipe up the excess soil and reset the clean cycle.
OVEN DOOR WILL • The oven is too hot. Allow the oven to cool below locking
NOT OPEN AFTER temperature.
A CLEAN CYCLE
OVEN NOT • Oven controls improperly set. See the Using the Self-Cleaning Oven
CLEAN AFTER section.
A CLEAN CYCLE • Oven was heavily soiled. Clean up heavy spillovers before starting the
clean cycle. Heavily soiled ovens may need to self-clean again or for a
longer period of time.
“LOCK DOOR” • The self-clean cycle has been selected but the door is not closed.
FLASHES IN Close the oven door.
THE DISPLAY
LOCKED DOOR • The oven door is locked because the temperature inside the oven has
LIGHT IS ON WHEN not dropped below the locking temperature. Press the CLEAR/OFF
YOU WANT TO COOK pad. Allow the oven to cool.
CONTROL SIGNALS • You forgot to enter a bake temperature or cleaning time. Press the
AFTER ENTERING BAKE pad and desired temperature or the SELF CLEAN pad and
COOKING TIME OR desired clean time.
DELAY START
“F—AND A NUMBER • You have a function error code. Press the CLEAR/OFF pad. Allow
OR LETTER” FLASH the oven to cool for one hour. Put the oven back into operation.
IN THE DISPLAY
• Disconnect all power to the oven for 30 seconds and then reconnect
power. If the function error code repeats, call for service.
DISPLAY GOES • A fuse in your home may be blown or the circuit breaker tripped.
BLANK Replace the fuse or reset the circuit breaker.
• The clock is in the black-out mode. See the Oven Control, Clock and
Timer section.
DISPLAY FLASHES • Power failure. Reset the clock.