Grizzly G1030 - Manual (Page 15)

G1030 Dust Collector -13-
Figure 8. Securing the bag to the collector
Collection/Filter Bags bolt through one side of the clamp, then the lock
nut, then thread the bolt through the other clamp.
Figure 9
Hook the loops of the two upper filter bags over
the upper support bracket.
Figure 10.
There are two collection bags which install onto
the bottom of the collectors. There are also two
filter bags (with loops on top) which install onto
the top of the collectors.
All the bags are attached in the same manner.
Slip the opening of the bag over the lip of the col-
lector and pull the strap tight to secure. Make
sure the strap is seated in the groove around the
entire circumference. Repeat this process for the
other three bags.
Figure 8.
Figure 9. Securing the bag clamps
Figure 10. Attaching bag loop to bracket
Inlet
Press the three-to-one inlet onto the inlet cover
flange.
Figure 11. Line up the hole in the inlet
with the threaded hole on the body and install
screw
Figure 11. Securing inlet onto cover
Slip the bag clamp over the bag and position it
next to the strap, making sure it is also seated in
the groove around the collector. Thread the long