Battery installation, Installation instructions – GE GNSV70FBL User Manual
Page 13
13
Installation Instructions.
Battery Installation
1. Use a small flat blade screwdriver or coin to remove the battery tray (A) at the side of the faucet base.
2. Install one CR2032, 3 volt battery (B) + side down into the battery tray (A) (Fig. 12).
3. Slide tray into faucet base (C) until the battery tray (A) edge is flush with the side of the base.
4. The blue light (D) will flash 5 times, indicating a proper installation and system reset.
5. Normally the light is off. After 6 months of use, the light will flash again every 30 seconds, indicating the proper time to replace the
filter canister.
NOTE: The blue light may stop blinking if it is allowed to blink for an extended period of time. To ensure proper operation, the battery should be replaced with
every filter change.
Fig. 12
+
–
(B) Battery
(C) Faucet base
(A) Battery tray
(D) Blue light
- Autotrol Performa ProSoft 960 Series (32 pages)
- SmartWater PNRQ15 (6 pages)
- SmartWater GXWH20F (16 pages)
- SmartWater GXSV10C (48 pages)
- Merlin (28 pages)
- PNRQ20FBB (84 pages)
- E4 (33 pages)
- GNSV25CBL (16 pages)
- GXSF27E (60 pages)
- GX1S01C (2 pages)
- ZDWC240 (16 pages)
- GXRM10RBL (64 pages)
- 400 Series (28 pages)
- SmartWater GXWH35F (2 pages)
- PNSF31Z01 (28 pages)
- F-801 (124 pages)
- GN1S04C (36 pages)
- 000 gpd (45 pages)
- GXCF20FBB (28 pages)
- 3020511 (4 pages)
- GXRM10G (64 pages)
- r10279v (8 pages)
- Z-10000 (128 pages)
- GNSV70F (2 pages)
- 268 (44 pages)
- WineChiller (32 pages)
- PNRQ21LRB (84 pages)
- GXPL03H (12 pages)
- GXSV65F (20 pages)
- MONACO 6000A (28 pages)
- GXFM03C (6 pages)
- GXSF35E (64 pages)
- GXRTDR (4 pages)
- Monogram ZDWI240WII (3 pages)
- GXSF30H (2 pages)
- GXFM07HWW (20 pages)
- GXSF4OH (64 pages)
- Profile Wine Chiller (32 pages)
- GXCF05D (24 pages)
- GXCF25FBS (28 pages)
- GNSV75F (2 pages)
- GNSH45E (64 pages)
- GXRM10GBL (2 pages)
- SmartWater GXRLQR (6 pages)
- GNULQ (16 pages)