Grizzly 17" Heavy Duty-Bandsaw G0513X2BF - Manual (Page 15)

G0513 Series Bandsaws
-13-
No adapter should be used with the
required plug. If the plug does not fit the
available receptacle, or the machine must
be reconnected for use on a different type
of circuit, the reconnection must be made
by a qualified electrician and comply with all
local codes and ordinances.
Grounding Requirements for 110V: the plug
specified under “Circuit requirements for 110V
operation” on the previous page has a grounding
prong that must be attached to the equipment-
grounding wire inside the specified power cord.
the plug must only be inserted into a matching
receptacle (see
Figure 6) that is properly installed
and grounded in accordance with all local codes
and ordinances.
Figure 6. typical l5-30 plug and receptacle.
Grounding Prong
is Hooked
Hot
Neutral
L5-30 GROUNDED
LOCKING
RECEPTACLE
L5-30
LOCKING
PLUG
For your own safety and protection of
property, consult an electrician if you are
unsure about wiring practices or electrical
codes in your area.
Improper connection of the equipment-grounding
wire can result in a risk of electric shock. The
wire with green insulation (with or without yellow
stripes) is the equipment-grounding wire. If repair
or replacement of the power cord or plug is nec-
essary, do not connect the equipment-grounding
wire to a live (current carrying) terminal.
Check with a qualified electrician or service per-
sonnel if you do not understand these grounding
requirements, or if you are in doubt about whether
the tool is properly grounded. If you ever notice
that a cord or plug is damaged or worn, discon-
nect it from power, and immediately replace it with
a new one.
Serious injury could occur if you connect
the machine to power before completing the
setup process. DO NOT connect to power
until instructed later in this manual.