Gold's Gym GGTL58608.0 - Manual (Page 9)

9
8. Have a second person hold the console assem-
bly near the Pulse Bar (66). Connect the
Console Ground Wire (102) on the Pulse Bar to
the ground wire from the console assembly.
Connect the console wire to the Upright Wire
(75). See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and
then try again. IF THE CONNECTORS ARE
NOT CONNECTED PROPERLY, THE CON-
SOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON. Lay the wires inside
the bottom of the Pulse Bar (66).
75
Console
Assembly
Console Wire
76
102
8
75
9. Set the console assembly on the Left and Right
Uprights (70, 76). Be careful not to pinch any
wires.
Attach the console assembly to the Pulse Bar
(66) with six 3/4" Screws (23). Start all six
Screws before fully tightening any of them.
23
Console Assembly
23
23
70 76
9
Ground
Wire
66
66
10. Identify the Left Handrail Cover (68), which has
a LEFT sticker on it. Slide the Left Handrail
Cover onto the left Handrail (62) and hold it
against the console assembly. Tighten two
Cover Screws (52) into the Left Handrail Cover
and the Left Upright (70); be careful not to
overtighten the Cover Screws.
Attach the Right Handrail Cover (74) in the
same way.
Console
Assembly
52
68
70
76
74
52
10
62
62