Grizzly G0689 - Manual (Page 14)

-12-
g0689 13" planer
Assembly
To test run the machine:
1. Make sure you have read the safety instruc-
tions at the beginning of the manual and that
the machine is setup properly.
2. Make sure all tools and objects used during
setup are cleared away from the machine.
3. Connect the machine to the power source.
4. Verify that the machine is operating correctly
by turning the machine ON.
—When operating correctly, the machine
runs smoothly with little or no vibration or
rubbing noises.
— investigate and correct strange or unusual
noises or vibrations before operating the
machine further. always disconnect the
machine from power when investigating or
correcting potential problems.
To attach the elevation crank assembly:
1. align the flat portion inside the crank bore
with the flat portion on the shaft, then place
the crank assembly on the elevation shaft.
2. thread the M6-1 x 20 button head screw with
the flat washer through the crank and into the
shaft to secure the crank in place, as shown
in
figure 6. do not over-tighten.
Test Run
once the assembly is complete, test run your
machine to make sure it runs properly and is
ready for regular operation.
the test run consists of verifying the following:
1) the motor powers up and runs correctly, and
2) the safety disabling key on the switch works
correctly.
if, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review
Troubleshooting on Page 24.
if you still cannot remedy a problem, contact our
tech Support at (570) 546-9663 for assistance.
3. attach the dust collection bag to the planer
dust outlet by sliding the clamp over the
mouth of the bag, placing the bag over the
dust outlet, then positioning and locking the
clamp over both the bag and the outlet, as
shown in
figure 7.
figure 7. Dust collection bag.
figure 6. attaching crank.
Crank
Screw
& Washer