Grizzly G0513P - Manual (Page 25)

G0513 Series Bandsaws
-23-
Installing Fence (G0513X2B &
G0513X2BF)
1. attach the rail plates to the front rail with the
(3) M6-1 x 20 cap screws, 6mm lock wash-
ers, and 6mm flat washers (see
Figure 24).
Figure 24. installing front rail onto table.
Knob
Flat
Washer
8mm
Flat Washer 6mm
lock Washer 6mm
lock Washer
8mm
Front rail
rail plate
Cap screw
M6-1 x 20
Cap screw
M8-1.25 x 20
2. attach the outer two rail plates with the round
and elongated mounting holes to the outer
part of the table bottom with (2) M8-1.25 x 20
knobs and 8mm flat washers.
3. attach the remaining rail plate with the round
mounting holes using (1) M8-1.25 x 20 cap
screw, 8mm lock washer, and 8mm flat
washer (see
Figure 24).
4. thread the fence handle into the fence, then
tighten the hex nut against the fence pivot
block (see
Figure 25).
Figure 25. Fence handle components.
hex Nut
Fence
handle
5. install the fence on the left-hand side of the
blade.
6. place the fence flush against the bandsaw
blade (see Figure 26).
Figure 26. Fence flush with blade.
8. re-tighten the pointer adjustment nut.
7. loosen the pointer adjustment nut (see
Figure 27) and set the pointer in line with "0"
on the measurement scale on the rail.
Figure 27. Calibrating fence pointer
(adjustment nut out of view).
pointer
pointer Nut