GarrettCom P62 - Manual (Page 38)

Magnum P62-Series Hardened Switches Installation and User Guide (05/05)
34
www GarrettCom com . .
5.0 TROUBLESHOOTING
All Magnum Ethernet products are designed to provide reliability and consistently high
performance in all network environments. The installation Magnum P62-Series Hardened Switch
is a straightforward procedure (see INSTALLATION, Section 3); the operation is also
straightforward and is discussed in Section 4.
Should problems develop during installation or operation, this section is intended to
help locate, identify and correct these types of problems. Please follow the suggestions listed
below prior to contacting your supplier. However, if you are unsure of the procedures described
in this section or if the Magnum P62-Series Hardened Switch is not performing as expected, do
not attempt to repair the unit; instead contact your supplier for assistance or contact GarrettCom
Customer Support.
5.1 Before Calling for Assistance
1. If difficulty is encountered when installing or operating the unit, refer back to the
Installation Section of the applicable chapter of this manual. Also check to make sure
that the various components of the network are interoperable.
2. Check the cables and connectors to ensure that they have been properly connected and
the cables/wires have not been crimped or in some way impaired during installation.
(About 90% of network downtime can be attributed to wiring and connector problems.)
3. Make sure that an AC power cord is properly attached to each Magnum P62-Series
Hardened Switch unit. Be certain that each AC power cord is plugged into a
functioning electrical outlet. Use the PWR LEDs to verify each unit is receiving power.
4. If the problem is isolated to a network device other than the Magnum P62-Series
Hardened Switch product, it is recommended that the problem device is replaced with a
known good device. Verify whether or not the problem is corrected. If not, go to Step
5 below. If the problem is corrected, the Magnum P62-Series Hardened Switch and its
associated cables are functioning properly.
5. If the problem continues after completing Step 4 above, contact your supplier of the
Magnum P62-Series Hardened Switch unit or if unknown, contact GarrettCom, Inc. by
fax, phone or email ([email protected]) for assistance.