Important – Gold's Gym GGSY2921.0 User Manual

Page 14

106

110

ATTACHING EXTERIOR BANDS

Remove the 1/2” x 1” Button Screw (110) with the 1/2”

Small Washer (82) from each side of the resistance

system. Remove the Side Covers (42) from the Left

and Right Covers (10, 11). Remove the 1/2” x 1”

Button Screw with the 1/2” Washer (106) from each

side of the resistance system.

Slide the four 17.5mm Spacers (A) onto the four

Resistance Rods (B). (See the inset drawing for cor-

rect orientation.) Slide the two removed 1/2” Washers

(106) onto two of the Rods.

Attach a Resistance Rod (B) and a Resistance Rod

with a 1/2” Washer (106) to the indicated locations on

the resistance system. Attach the other two Resistance

Rods to the other side of the resistance system.
Slide an Exterior Band (C) onto each set of Resistance

Rods (B). For more resistance, add a second Band to

each set of Rods. Note: It may be necessary to

stretch the Bands to slide them onto the Rods.

Secure the Exterior Bands with the two Clips (D).

To purchase a MAX PACK, call our Customer Service

Department at the number listed on the front cover of

this manual. The MAX PACK shown is model number

GGMC0921.

STORING THE RESISTANCE SYSTEM

To store the resistance system, secure the Seat Knob

(36) into the adjustment hole in the Bench Frame (2)

that is closest to the Leg Developer (21) (see

ADJUSTING THE BACKREST on page 12). Remove

the indicated Bench Knob (41) from the Base (4) and

lift the Leg Developer so that it rests against the Left

and Right Uprights (8, 9). Engage the Knob into the

indicated hole in the Base.

IMPORTANT:

Always place the

same number of Exterior Bands (C) on each

side of the resistance system. Use only the

Bands included with a GOLD’S GYM MAX

PACK. Always secure the Bands with the Clips

(D).

Small

Hole Large

Hole