Configuration men u – Epson EH-TW4000 User Manual

Page 37

Configuration Menu Functions

Configuration Men

This reduces the noise which can be generated around the edges of images when projecting MPEG
images. Three modes are available. Select your preferred mode.

Set to "ON" to reduce block noise which can occur when projecting MPEG images which have been
compressed at a low bit rate.

(This can be set when NTSC signals are being input from the [Video] / [S-Video] input ports, or when
component video signals are being input from the [Component] input port.)
If using products designed for destinations such as South Korea that have different black level (setup
level) settings, use this function to obtain correct images. Check the specifications of the connected
equipment when changing this setting.

(Setting is only possible when Color Mode is "Natural", "Theatre", "Theatre Black 1", or "Theatre Black
2", and composite video, S-video, or component video signals are being input.)
If bright white areas of images such as clouds and T-shirts on the beach in summer appear uneven and
overexposed, set to "On". When set to "On", the "HDMI Video Range" setting will be ignored.

(Setting is not possible when composite video , S-Video , or computer signals are being input.)
This changes the display area (the part of projected images).

• 100% - 92% :When 100% is set, the top and bottom of the image is sometimes affected by electrical

interference depending on the image signal. In such cases, try to adjust the display
position ("Position").

p.34

• Auto

:Displayed when the signals from [HDMI1] / [HDMI2] input port are being input. Signals

are automatically projected at 100% or 92% size depending on the input signals. (Not
displayed when the equipment's DVI port is connected to the projector's [HDMI1] /
[HDMI2] input port.)

(Setting is possible only when "EPSON Super White" is "Off". Setting is not possible, however, when
"Color Mode" is set to "x.v. Color.")
When the [HDMI1] / [HDMI2] input port of the projector is connected to a DVD player, for example, set
the video range of the projector to suit the video range setting of the DVD player. The setting at the DVD
player can be either Normal or Expand.

(This setting can be made only when a 1080p/24Hz signal is being input to the [Component] or
[HDMI1], [HDMI2] input terminals.)
For a 1080p/24Hz input signal, you can select between 2-2 pull-down projection or 2-3 pull-down
projection. Selecting "On" sets the 2-2 pull-down.

(This setting can be made only when 480i, 1080i/60Hz or 1080p/24Hz signals are being input to the
[Component], [HDMI1] or [HDMI2] input ports or when NTSC, M-PAL or PAL60 signals are being
input to the [Video] or [S-Video] input ports.) You can select whether images are projected with the 4-4
pull-down or the 2-3 pull-down. Set to "ON" to project with 4-4 pull-down.

All the adjustment values on the "Signal" menu, except "Aspect ", are returned to their default values.

Displayed for input sources other than computer image

Mosquito NR (EH-TW4000 only)

Block NR (EH-TW4000 only)

Setup Level

EPSON Super White

Output Scaling

HDMI Video Range

2-2 Pull-down (EH-TW3000/TW2800 only)

4-4 Pull-down (EH-TW4000 only)

Reset

*1 The setting values are stored separately for each image source and signal type.