Epson EH-TW4000 - Manual (Page 15)

13
Install
ing the Pr
ojector
Preparing the Remote Control
Inserting batteries into the remote control
Using the remote control
If delays in the responsiveness of the remote control occur or if it does not operate
after it has been used for some time, it probably means that the batteries are
becoming flat. If this happen, replace the batteries with two new batteries. Use two
new AA-size alkali batteries or manganese batteries as replacement batteries.
Batteries other than AA-size alkali batteries or manganese batteries cannot be used.
At the time of purchase, the batteries are not
inserted into the remote control. Insert the supplied
batteries before using the remote control.
Insert the batteries in the correct direction.
Close the cover. Check the (+) and (-) indications inside
the battery compartment and insert the
batteries so that they face correctly.
Lift up the battery cover while pressing its
tab.
TIP
Approx.30
Approx.30
Approx.30
Approx.10m
Operating distance
Approx.30
Approx.30
Operating range (horizontal)
Operating range (vertical)
Approx.10m
Operating distance
Approx.60
Approx.10 *
Approx.30
Approx.10m
Operating distance
Approx.10m
Operating distance
* Remote control signals
cannot be received within this
range.