GE Monogram Built-In All-Refrigerator/Freezer - Manual (Page 18)

18
Installation Instructions
STEP 9 INSTALL FRAMED PANELS
(TRIMMED MODELS ONLY)
• There are two sets of holes in the handle side trim.
Replace the handle side trim by installing the original
screws in the FRONT screw holes.
• Secure the handle to the door using the REAR
screw holes.
Use Rear Holes
to Secure Handle
Use Front Holes
to Secure Trim
Right hand models shown. Use the same instructions
for left hand models.
IF YOU ARE INSTALLING OVERLAY PANELS,
GO TO STEP 10A.
Install Door Panel:
• Open the door to 90°. Remove the 6 Phillips head screws
from the door handle.
• Remove the handle. Retain all screws.
• Remove the 6 screws holding the trim, lift off the trim.
Retain the screws.
• Slide the framed panel into the door trim.
Standard supplied handle shown
in 1/4" panel position.
Door
Door Trim Handle
Trim