GE Monogram Built-In All-Refrigerator/Freezer - Manual (Page 10)

Installation Instructions
10
DO NOT, UNDER ANY
CIRCUMSTANCES, CUT
OR REMOVE THE THIRD
(GROUND) PRONG
FROM THE POWER CORD.
DO NOT USE AN ADAPTER PLUG TO CONNECT THE UNIT
TO A 2-PRONG OUTLET.
DO NOT USE AN EXTENSION CORD WITH
THIS APPLIANCE.
HARDWARE SUPPLIED TOOLS REQUIRED
Tin snips to cut banding #2 Phillips screwdriver
Stepladder
Drill and 1/2", 3/16" bits
Bucket
1/4", 1/2", 5/16", 7/16" socket
Level
Safety glasses
Appliance
hand truck
Pliers
Tubing cutter Stud finder
7/16" and 1-1/4"
open-end wrench
GROUNDING THE UNIT
IMPORTANT - (Please read carefully)
FOR PERSONAL SAFETY, THIS APPLIANCE MUST
BE PROPERLY GROUNDED.
The power cord of this appliance is equipped with
a three-prong (grounding) plug which mates with
a standard three-prong (grounding) wall receptacle
to minimize the possibility of electric shock hazard
from this appliance.
Have the wall outlet and circuit checked by
a qualified electrician to make sure the outlet
is properly grounded.
Where a standard 2-prong wall outlet is encountered,
it is your personal responsibility and obligation to have
it replaced with a properly grounded 3-prong wall
outlet.
4 Washers
2 Hair Pin Cotters
3 lag screws
5 toggles with bolts
Water filter
bypass plug
Supplied Toekick
Toekick
(Secured to side of unit.)
Anti-Tip bracket
(Secured to side of unit.)
MATERIALS REQUIRED
• 1/4" copper water line tubing or GE SmartConnect ™
Refrigerator Tubing kits
• Water shut-off valve (optional but recommended)
• Custom panels for door and grille panel
• Screws to secure unit to cabinetry.
• Stick-on hook and loop fastener strips for 1/4" side
panels
FLOORING
For proper installation, this product must be placed
on a level surface of hard material that is at the same
height as the rest of the flooring. This surface should
be strong enough to support a fully loaded refrigerator
or freezer, or approximately 1,200 lbs. per unit.
NOTE: Protect the finish of the flooring. Cut a large
section of the cardboard carton and place under
the product where you are working.
NOTE: Not recommended for installation on carpeted flooring.
Custom handle trim