GE Monogram Built-In All-Refrigerator/Freezer - Manual (Page 17)

STEP 7 ADJUST DOOR SWING
NOTE: This refrigerator has a 2-position door stop.
When space does not allow the door to swing open
fully to 130°, you may change the door swing to a 90°
opening. Skip this step if door opening is satisfactory
for your installation situation.
STEP 8 INSTALL GRILLE PANEL
(TRIMMED MODELS ONLY)
• Raise the access panel to the stop position.
• Open the door to view the bottom hinge. Note
the door stop pin locations. The pin is factory-installed
in the 130° position.
• Close the door. From below, use pliers to unscrew
the door stop and reinstall into the 90° position.
• Loosen the screws on the side trim behind the frame.
Remove the bottom trim.
• Slide the panel over the metal baker panel
and into the trim.
• If necessary, tap with a wood block until the panel
slips under the top trim piece.
• Reassemble the bottom trim. Tighten the screws.
• Adjust the hinge spring to accommodate the panel
weight, if necessary.
Installation Instructions
17
Pin Location
For 90°
Door Swing
Pin Location
as Shipped
For 130°
Door Swing