Memory, You see a “memory error” message, To run the memory diagnostic tool – Gateway GT5062b User Manual
Page 97: You see a “not enough memory” error message, Memory card reader, Modem (cable or dsl), My computer cannot connect to the internet, Memory memory card reader modem (cable or dsl)
www.uk.gateway.com
91
Memory
You see a “Memory error” message
•
Use the Memory Diagnostic Tool to inspect your system
memory.
To run the Memory Diagnostic Tool:
•
Click (Start), type
Memory Diagnostic Tool,
then press E
NTER
. Click Restart now and check for
problems. Your computer restarts and runs the
memory diagnostics.
You see a “Not enough memory” error message
•
Close all programs, then restart your computer.
Memory card reader
Drive letters for the memory card slots do not appear in
the Computer window
•
The memory card reader was temporarily uninstalled
using the Remove Hardware icon in the system tray.
Reboot your computer, and your card reader will be
re-installed.
Modem (cable or DSL)
My computer cannot connect to the Internet.
•
Make sure that your modem is connected to the
network jack.
•
See the documentation that came with your modem for
additional troubleshooting information.
Help
For more information about troubleshooting memory errors, click Start,
then click Help and Support. Type the phrase
memory error in the Search
Help box, then press E
NTER
.
Tip
For the location of your network jack, see your setup poster or
8512243.book Page 91 Monday, February 12, 2007 4:35 PM