Graco 13785-7-00 - Manual (Page 51)

belt because of the upright angle at which you must
pull. You may have to unbuckle the seat belt, estimate
a seat belt length that will make the seat belt very tight,
then buckle it again.
!
A lap/shoulder combination belt with a
latchplate that can slide freely along the belt
Í requires the locking clip, unless your vehicle’s
seat belt can be converted in another way that is
described in your vehicle owner’s manual. See
your vehicle owner’s manual to find out if your
seat belt can be converted to prevent movement
of the lap portion of the belt. Otherwise, the
locking clip MUST be used.
To install the locking clip:
a. Tighten the buckled seat belt by pushing down hard on the safety
seat and pulling hard on the shoulder belt.
b. While continuing to push down on the safety seat, let go of the
shoulder strap and pinch the two straps together just behind the buckle
tongue.
47
Н