beautypg.com

Foundry Networks IRONPOINT 250 User Manual

Page 37

background image

Installing the IronPoint 250 Access Point

August 2007

© 2007 Foundry Networks, Inc.

4-9

US-UNITED_STATES, UY-URUGUAY, VE-VENEZUELA, VN-VIETNAM

5. Configure the TCP/IP address. The default IP address for the access point is 169.254.1.1 with a

255.255.0.0 subnet mask and a default gateway of 169.254.1.254. To change the access point's
IP address, for example, to 192.168.1.10 with a 24-bit subnet mask and a default gateway of
192.168.1.254, enter:

Foundry AP#configure

Foundry AP(config)#interface ethernet

Foundry AP(if-ethernet)#ip address 192.168.1.10 255.255.255.0 192.168.1.254

Foundry AP(if-ethernet)#end

Foundry AP #

Syntax: interface ethernet

ip address

6. Confirm the Country Code and TCP/IP settings with the show system command. Do not

proceed unless the information displayed is correct. For example, to confirm the country code of
the United Kingdom and the TCP/IP address of 192.168.8.10/24, enter:

Foundry AP # show system

Syntax: show system

The command displays the following information:

Foundry AP # show system

System Information

============================================================

Serial Number : SACC1200KA

System Up time : 0 days, 0 hours, 5 minutes, 25 seconds

System Name : Foundry AP

System Location :

System Contact : Contact

System Country Code : GB - UNITED KINGDOM

MAC Address : 00-0C-DB-813-882

IP Address : 192.168.8.10

Subnet Mask : 255.255.255.0

Default Gateway : 192.168.8.254

VLAN State : DISABLED

Management VLAN ID(AP): 1

IAPP State : ENABLED

DHCP Client : DISABLED

HTTP Server : ENABLED

HTTP Server Port : 80

HTTPS Server : ENABLED

HTTPS Server Port : 443

Slot Status : Dual band(a/g)

Software Version : 01.2.03.00Tw8

SSH Server : ENABLED

SSH Server Port : 22

Telnet Server : ENABLED

============================================================

7. Power down the access point.

8. Connect one end of the Ethernet cable to the RJ-45 connector on the access point.