Furuno FAR-28x7 Series - Manual (Page 84)

1. RADAR OPERATION
1-58
[BARGE INFORMATION]
1 BACK
2 BARGE MARK
OFF/ON
3 BARGE SIZE
LENGTH
0ft
WIDTH 0ft
4 ARRANGEMENT
0
0
0
0
0
Barge icon
Barge icon
1. Roll the trackball to choose the MENU box at the right side of the display and
then push the left button to display the MAIN menu.
2. Roll the wheel to choose MARK and then push the wheel or the left button to
show the MARK menu.
3. Roll the wheel to choose 2 OWN SHIP MARK and then push the wheel or the
left button.
4. Roll the wheel to choose OFF or ON as appropriate and then push the wheel
or the left button.
5. Push the right button twice to close the menu.
1.32.5 Barge marker
You may mark the locations of barges on the display. Set up barge information
as follows:
1. Roll the trackball to choose the MENU box at the right side of the display and
then push the left button to display the MAIN menu.
2. Roll the wheel to choose MARK and then push the wheel or the left button to
show the MARK menu.
3. Roll the wheel to choose 7 [BARGE MARK] and then push the wheel or the
left button.
BARGE INFORMATION menu
4. Roll the wheel to choose 2 BARGE MARK and
push the wheel. Choose ON and push the wheel.
5. Choose 3 BARGE SIZE and push the wheel. Enter
length (three digits) and width (two digits) of barge.
6. Choose 4 ARRANGEMENT and push the wheel.
This item lets you set a single barge or a barge
chain. Roll the wheel to choose one of the five
arrangements and push the wheel. Roll the wheel
to choose number of barges (max. 9) to display.
As you roll the wheel the squares light or
extinguish and the number of barges chosen
appears at the right side.
7. Push the right button twice to close the menu.