beautypg.com

3 sart (search and rescue transponder), 1 sart description – Furuno FAR-28x7 Series User Manual

Page 123

background image

2. RADAR OBSERVATION

2-5

2.3

SART (Search and Rescue Transponder)

2.3.1 SART

description

A Search and Rescue Transponder (SART) may be triggered by any X-Band (3
cm) radar within a range of approximately 8 nm. Each radar pulse received
causes it to transmit a response which is swept repetitively across the complete
radar frequency band. When interrogated, it first sweeps rapidly (0.4 µs) through
the band before beginning a relatively slow sweep (7.5 µs) through the band
back to the starting frequency. This process is repeated for a total of twelve
complete cycles. At some point in each sweep, the SART frequency will match
that of the interrogating radar and be within the pass band of the radar receiver.
If the SART is within range, the frequency match during each of the 12 slow
sweeps will produce a response on the radar display, thus a line of 12 dots
equally spaced by about 0.64 nautical miles will be shown.

When the radar to the SART is reduced to about 1 nm, the radar display my
show also the 12 responses generated during the fast sweeps. These additional
dot responses, which also are equally spaced by 0.64 nautical miles, will be
interspersed with the original line of 12 dots. They will appear slightly weaker
and smaller than the original dots.

9500 MHz

9200 MHz

Radar antenna
beamwidth

Screen A: When SART
is distant

Screen B: When SART
is close

Lines of 12 dots
are displayed in
concentric arcs.

Echo from SART

Position of
SART

Own ship
position

Own ship
position

SART mark
length

Radar receiver
bandwidth

Sweep time

7.5

μ

s

95

μ

s

Sweep start

High speed sweep signal

Low speed sweep signal

24 NM

1.5 NM

Position of
SART

Echo from
SART

SART