Furuno FAR-28x7 Series - Manual (Page 209)

5. VIDEO PLOTTER OPERATION
5-21
[NAV LINE•WPT (1/2)]
1 BACK
2 NAV LINE DATA
OFF/EXT
DATA/
INTERNAL DATA/
WPT MARK*
3 NAV LINE SELECT
- -
FORWARD/REVERSE
4 SKIP NEXT WPT
5 NAV LINE WIDTH
0.0NM
6 [WPT SET]
7 [WPT LIST]
8 [NAV LINE SET]
9 [NAV LINE LIST]
0 NEXT
6. With the MARK box selected, roll the wheel to display waypoint number
desired and then push the left button. The cursor jumps into the effective
display area and the guidance box reads “MARK / EXIT.”
7. Roll the trackball to place the cursor where you want to inscribe a waypoint
mark and then push the left button to inscribe the mark. The waypoint mark
(“ ” + waypoint number) appears at the location selected. (You can see the
range and bearing to the cursor location by monitoring the mark range and
bearing indication just below the MARK box.)
• To enter another waypoint, push the right button when the guidance box reads
“MARK / EXIT” and then repeat steps 6-8. (“WPT” should be chosen on the
MARK menu.)
• To quit entering waypoints, push the right button when the guidance box reads
“MARK / EXIT.”
Entering waypoints by manual input of latitude and longitude
1. Roll the trackball to choose the MENU box at the right side of the screen and
then push the left button.
2. Roll the wheel to choose 8 [NAV LINE•WPT] and then push the wheel or the
left button.
* Not available on IMO or A type
NAV LINE•WPT menu