FujiFilm F450 User Manual

Page 40

Viewing

Images

Windows XP

1 The “Found New Hardware” help message

appears in the bottom-right corner of your screen.
This message will close when the settings are
completed. No action is required.

●

This step is not required for subsequent connections.

Proceed to “USING FinePixViewer” on P.80.

◆

Regarding the icons

◆

The next time you connect the camera, the removable disk drive icon and name change to the
“FinePix” icon and name.

2 Specify the settings in the “AutoPlay” dialog box.

h When FinePixViewer is included in the list of actions to perform

Select “Viewing images using FinePixViewer” and then select the “Always do the selected
action” checkbox (This checkbox may not be shown in some cases).
Click the [OK] button to launch FinePixViewer.

h When FinePixViewer is not included in the list of actions to perform

Select “Take no action” and then select the “Always do the selected action” checkbox. (This
checkbox may not be shown in some cases).
Click the [OK] button and launch FinePixViewer manually.

3 A new removable disk icon appears in the “My Computer” window.

FinePixViewer automatically starts up and the Save Image Wizard window (Save Image
dialog box) appears. Follow the instructions provided on screen to save the images at this
point. To proceed without saving the images, click the [Cancel] button.

●

The Windows CD-ROM may also be required during installation. In this event, change CD-ROMs as directed by the
on-screen instructions.

h FinePixViewer automatically starts up and the

Save Image Wizard window (Save Image
dialog box) appears. Follow the instructions
provided on screen to save the images at this
point. To proceed without saving the images,
click the [Cancel] button.

✽ Screen for Windows 98 SE

Windows 98 / 98 SE / Me / 2000 Professional / Macintosh

h A removable disk icon appears and you can use

your PC to transfer files to and from the camera.

Windows

Macintosh

If the above operations do not occur, you do not have the required software programs or drivers installed
on your PC. Complete the required PC setup procedures. Then reconnect the camera to your PC.

Set a PC

6.2 CONNECTING TO A PC

6.2.2 Disconnecting the camera

Windows

Once the image has been saved, the “Remove Camera/Media” window appears (Save Image
Wizard Windows). To disconnect the camera, click the [Remove] button.

Macintosh

Once the image has been saved, the “Remove camera/media” window appears (Save Image
dialog box). To disconnect the camera, click the [OK] button.

1 When the “It is now safe to disconnect the

camera” message appears, click the [OK] button
and disconnect the camera.

2 Press the “POWER” button on the cradle to turn

the power off.