Friedrich ZQ08A10C - Manual (Page 5)

—5—
2.1 MECHANICAL PARTS
2.1.1 FRONT GRILLE
1. Open the INLET GRILLE downward and remove
the air filter.
2. Remove the screw which fastens the FRONT GRILLE.
3. Pull the FRONT GRILLE from the right side.
4. Remove the FRONT GRILLE.
5. Re-install the component by referring to the above
removal procedure. (See figure 1)
2.1.2 CABINET
1. After disassembling the FRONT GRILLE, remove
two screws which fasten the CABINET at both
sides.
2. Remove two screws which fasten the CABINET at
back.
3. Pull the BASE PAN forward. (See figure 2)
2.1.3 CONTROL BOX
1. Disconnect the unit from the power source.
2. Remove the front grille. (Refer to section 2.1.1)
3. Remove the cabinet. (Refer to section 2.1.2)
4. Remove the screw which fastens the control box
cover.
5. Remove the housing which connects motor wire in
the control box.
6. Remove the 3 leads from the compressor.
(Refer to section 2.3.1)
7.Discharge the capacitor by placing a 20,000
ohmresistor across the capacitor terminals.
8. Remove the 2 screws which fasten the control
box.(See Figure 3)
9. Pull the control box forward completely.
10. Re-install the components by referring to the
removal procedure, above. (See Figure 3)
(Refer to the circuit diagram found on page 24 in
this manual or on the control box.)
2. DISASSEMBLY INSTRUCTIONS
— Before disassembling, turn the POWER SWITCH to OFF and disconnect the power cord.
Shipping screws
Figure 1
Figure 2
Figure 3