Foundry Networks AR3202-CL - Manual (Page 222)

Multicasting
June 2004 © 2004 Foundry Networks, Inc. 14 - 5
membership information enables the router to forward traffic only from those sources from which receivers
requested the traffic.
IGMPv3 supports applications that explicitly signal sources from which they want to receive traffic. With IGMPv3,
receivers signal membership to a multicast host group in the following two modes:
• INCLUDE mode: In this mode, the receiver announces membership to a host group and provides a list of IP
addresses (the INCLUDE list) from which it wants to receive traffic.
• EXCLUDE mode: In this mode, the receiver announces membership to a host group and provides a list of IP
addresses (the EXCLUDE list) from which it does not want to receive traffic. This indicates that the host wants
to receive traffic only from other sources whose IP addresses are not listed in the EXCLUDE list. To receive
traffic from all sources, like in the case of the Internet Standard Multicast (ISM) service model, a host
expresses EXCLUDE mode membership with an empty EXCLUDE list.
IGMPv3 is used by the hosts to express their desire to be a part of the source-specific multicast (SSM) which is an
emerging standard used by routers to direct multicast traffic to the host only if its is from a specific source.
IGMP Commands
The IGMP commands supported are:
T ABLE 6 IGMP C OMMANDS
Enabling igmp Foundry/configure > ip igmp
Disabling igmp Foundry/configure > no ip igmp
Enabling igmp Foundry/configure/ip/igmp# interface dlci-no]
Disabling igmp Foundry/configure/ip/igmp# no interface
Configuring version Foundry/configure/ip/igmp/interface ethernet0# version
Configuring Query
Interval Foundry/configure/ip/igmp/interface ethernet0# query-
interval
Configuring Maximum
Response Time Foundry/configure/ip/igmp/interface ethernet0# query-
response-interval
Configuring Last
Member Query Interval Foundry/configure/ip/igmp/interface ethernet0# last-
member-query-interval
Configuring Last
Member Query Count Foundry/configure/ip/igmp/interface ethernet0# last-
member-query-count
Configuring Startup
Query Interval Foundry/configure/ip/igmp/interface ethernet0# startup-
query-interval
Configuring Startup
Query Count Foundry/configure/ip/igmp/interface ethernet0# startup-
query-count
Configuring Robustness Foundry/configure/ip/igmp/interface ethernet0# robustness
Configuring Ignore-v1-
message Foundry/configure/ip/igmp/interface ethernet0# [no] ignore-
v1-messages
Configuring Ignore-v2-
message Foundry/configure/ip/igmp/interface ethernet0# [no] ignore-
v2-messages