FUJITSU PRIMERGY 4Gbit/s FC I/O Modules - Manual (Page 10)

48
1.4
4Gbit/s FC I/O Module to ETERNUS
Connections
This section explains the connection of the 4Gbit/s FC I/O Module and ETERNUS.
Fabric connection
Connect to the ETERNUS via FC Switch Blade.
1.5
Notes on Replacing the 4Gbit/s FC I/O Module
When an operating 4Gbit/s FC I/O Module has been replaced with a new 4Gbit/s FC I/O Module, it
may be necessary to change the storage and FC Switch Blade settings because the WWN of the
4Gbit/s FC I/O Module will change.
1.6
Points to Note When Using This Driver
Event log
When the system is started using this driver, the following logs are stored in the event viewer system
log. They can be ignored.
PRIMERGY BX620 S3/BX620 S4
PG-FCD201
BX600 S3 chassis
ETERNUS3000/
ETERNUS6000
FC Switch Blade (PG-FCS103)
FC Switch Blade (PG-FCS103)
5QWTEGGNZRNWU
'XGPV+&
6[RG+PHQTOCVKQP
&GUETKRVKQP
6JGFGUETKRVKQPHQT'XGPV+&=?KP5QWTEG=GNZRNWU?ECPPQVDGHQWPF
6JGNQECNEQORWVGTOC[PQVJCXGVJGPGEGUUCT[TGIKUVT[KPHQTOCVKQPQT
OGUUCIG&..HKNGUVQFKURNC[OGUUCIGUHTQOCTGOQVGEQORWVGT;QWOC[
DGCDNGVQWUGVJG#7:5174%'HNCIVQTGVTKXGVJKUFGUETKRVKQPUGG
*GNRCPF5WRRQTVHQTFGVCKNU6JGHQNNQYKPIKPHQTOCVKQPKURCTVQHVJGGXGPV