FOCUS Enhancements DVCPRO50 - Manual (Page 65)

FS-100 Functions
FS-100 Portable DTE Recorder 47
Setting Up Master and Slave FS-100
Step 1: Connect the camcorder to the master FS-100, DV I/O connector
using the supplied FireWire cable.
Step 2: Master
Power on unit.
Go to the
HDD Mode menu screen and enable
USE EXT FS-100 .
Step 3: Connect the FS-100s through the units Computer I/O connectors
using a 6-pin to 6-pin FireWire cable.
Step 4: Slave
Power on the unit
Go to the
HDD Mode screen and enable DD DRIVE .
Step 5: Master
Begin recording or playback using the master FS-100.
Use DD Drive Mode when Connecting to a PC
It is important to take the master FS-100 out of USE EXT FS-
100 mode before attempting to connect to a computer.
To do this, select DD DRIVE from the HDD Mode screen.
This returns use of the unit to hard disk mode.
STOP 1 - 001
COUNTER
00 : 00 : 00 : 00
DISK 1 000min
SYNC DISP LOCK
CONNECT
COMPUTER THEN
ENABLE BYPASS
SUCCESS
EXIT
4
3
2
1
Master FS-100 Slave FS-100