FujiFilm FinePix 420 - Manual (Page 22)

43
Advanced Features
42
1 1 Set the Mode switch to “w”.
2 Press “d” or “c” to select the movie file.
2 1 Press “b” to play the movie.
2 The LCD monitor shows the playback time and a
playback progress bar.
0 1 0 2
0 1
0 2
r PLAYING BACK MOVIES
PLAYBACK MODE
● ! Movies cannot be played back using multi-frame playback.
Use the “DISP” button to select single-frame playback.
Indicated by the “ r ” icon.
Movies are displayed one size smaller than still
images.
● ! If the subject of the movie is very bright, white streaks may
appear on the image during playback. This is normal and
does not indicate fault.
■ Playing Back Movies
Control Description
Playback
Playback begins.
The movie automatically stops when playback ends.
Pause/Resume
Pauses the movie during playback.
Press “b” again to resume playback.
Stop
Stops playback.
✽ Press “d” or “c” while movie playback is stopped to go back
to the previous file or advance to the next file respectively.
Fast forward/Rewind Press “d” or “c” during playback to skip forwards or backwards
through the movie.
Skip playback
i Press “d ” or “c ” when the movie is paused, the movie
advances or goes back one frame.
i Hold down “d” or “c” to move through the frames quickly.
◆
Playing back movie files
◆
i It may not be possible to play back a movie file that was recorded on a camera other than the FinePix
F420.
i To play back movie files on a computer, save the movie file on the xD-Picture Card to the
computer’s hard disk and then play back the saved file.
When paused
Rewind Fast forward
5 A counter appears in the top-right corner of the
LCD monitor during recording shows the remaining
time.
● ! When the Power save function ( ➡P.58) is active, after 30
seconds of recording, the LCD monitor gets a bit dark. Press
the “DISP” button to recover the LCD monitor brightness.
● ! If the brightness of the subject changes during movie
recording, the sound of lens operation may be recorded.
● ! Some wind noise may be recorded in movie recorded
outdoors.
● ! When the remaining time runs out, recording automatically
ends and the movie is saved onto the xD-Picture Card.
● ! If recording is stopped immediately after it begins, about 1
second of movie is recorded onto the xD-Picture Card.
6 Press the Shutter button during recording to end
recording.
4 Press the Shutter button down fully to start
recording.
r RECORDING MOVIES
MOVIE MODE
● ! The brightness and color of the LCD monitor shown during
movie recording may differ from those shown before
recording begins.
● ! You do not need to hold down the Shutter button.
Pressing the Shutter button down fully locks the
focus, but the exposure varies automatically
according to the scene being shot.