FujiFilm FinePix A205S - Manual (Page 16)

31
Advanced Features
30
1
2
PHOTOGRAPHY MENU OPERATION
1 Press the “MENU/OK” button to display the menu.
2 Press “d” or “c” to select the menu item and
“a” or “b” to change the setting.
3 Press the “MENU/OK” button to confirm the
selection.
When you enable the setting, an icon appears in
the top-left corner of the LCD monitor.
● ! The settings available in the menu screen vary depending on
the Still photography mode.
0 1
0 2
0 3
PHOTOGRAPHY MENU STILL PHOTOGRAPHY MENU ✽ SELECTING a AUTO /s MANUAL (➡P.29)
Use the table below as a guide for selecting the
best setting.
y QUALITY SETTINGS IN STILL PHOTOGRAPHY MODE
● ! The numbers to the right of each setting show the number of
available frames.
● ! When you change the quality, the number of available frames
also changes (
➡P.21).
Printing at A4 or A5 size or printing part of the image cropped at A6 size.
Quality mode
3 3 MB (2048 × 1536)
✽ FinePix A210 only
Best for A6 or A5 size prints. 2 2 MB (1600 × 1200)
Best for A6 size prints. 1 1 MB (1280 × 960)
For an image attached to E-mail or used on a website. ` 0.3 MB (640 × 480)
Sample Uses
1 The self timer is used in situations such as group
shots where the photographer is included in the
shot.
Setting the self-timer to “ON”, “*” appears on the
LCD monitor.
In this mode, a timer runs for roughly 10 seconds
before the shutter is released.
1 Position the AF frame over the subject.
2 Press the Shutter button down halfway to focus
the shot.
3 Without releasing the Shutter button, press the
button all the way down (fully pressed) to start
the self-timer.
Beep
2
0 1
0 2 0 3
* SELF-TIMER PHOTOGRAPHY
● ! The self-timer is automatically switched off in the following
situations:
i When shooting ends
i When the camera is switched to“a” or “s” mode
i When the Mode switch setting is moved to another setting
i When the camera is switched off
● ! The AF/AE lock can be also used ( ➡P.22).
● ! Take care not to stand in front of the lens when you press the
Shutter button as this can prevent the correct focus or
brightness (exposure) being obtained.
The self-timer lamp lights steadily for roughly 5
seconds and then blinks for another 5 seconds,
after which the shot is taken.
A countdown is displayed on the LCD monitor
indicating the time remaining until the picture is
taken.
Self-timer mode is automatically cancelled after
each shot.
3
4
● ! To stop the self-timer, once it has started running, press the
“BACK” button.