FUJITSU fi-5900C - Manual (Page 27)

fi-5900C Image Scanner Getting Started AP- 4
Appendix 2
DAILY CARE
■ Cleaning Materials
For details about the cleaning materials, contact the
FUJITSU scanner dealer where you purchased the scan-
ner.
■ Cleaning Method
The ADF must be cleaned with a lint-free cloth moist-
ened with the Cleaner F1.
The Feed roller must be cleaned with a lint-free cloth
moistened with the Cleaner F2.
■ Locations and Cycle for Cleaning
For details on the cleaning the ADF, refer to "4.Daily
Care" in the fi-5900C Operator’s Guide on the Setup
CD-ROM".
WARNING
During its operation, the inside
glass of the ADF becomes very hot.
Before you clean inside the scan-
ner, turn off its power and unplug
the AC adapter from the outlet. Wait
for at least 15 minutes.
Do not turn off the scanner when
you clean the Feed rollers or Eject
rollers.
Cleaning
Materials
Parts No. Remarks
Cleaning sheet CA99501-
0016 20 sheets/pack
For the cleaning method,
refer to "4 Daily Care in
the fi-5900C Operator"s
Guide.
Cleaner F1
(or isopropyl
alcohol)
CA99501-
0013 1 bottle
Moisten a cloth with this
fluid and wipe the scan-
ner to clean.
Cleaner F2 CA99501-
0014
1 bottle
Moisten a cloth with this
fluid and clean metal
rollers only.(Do not use
for any other parts.)
Cotton swab Commercially available
Lint-free dry
cloth
Part to clean Standard Cleaning Cycle
Pad Clean these parts after every
10,000 scans.
Pick rollers
Brake roller
Separator rollers
Feed rollers
Pinch rollers
Transport path
Glass
Skew-detection sensor
Document sensor
ATTENTION
The scanner must be cleaned more fre-
quently if you scan any of the following
type of sheets:
• Documents of coated paper
• Documents that are almost completely
covered with printed text or graphics
•
Chemically treated documents such
as carbonless paper
•
Documents containing a large amount
of calcium carbonate
•
Documents written with pencil